Crown Pulse 4×300 4 x 300W 4Ω / 2 x 600W 8Ω

Crown Pulse 4x300 4-channel power amplifier


The Crown Pulse 4×300 is a 4-channel power amplifier producing 300W per channel into 4Ω or 170W per channel into 8Ω. The Pulse 4×300 is ideal for powering monitor wedges on a small stage. The Pulse 4×300 can also be bridged, producing 2 x 600W at 8Ω or 2 x 660W at 4Ω.

• Switch Mode Power Supply delivers great performance without the weight.
• Microprocessor supervision of power sup- plies provides overall system protection.
• Accurate front-panel indicators and level controls.
• Choice of balanced XLR and 1⁄4-inch phone inputs.
Controls: Power switch, bridge mode switches, detented level controls (these may be made tamper-proof).
• Choice of Speakon® and/or binding post outputs.
• Four-channel operation for increased system flexibility.
• All this performance and reliability in only 2 rack spaces.

Input Sensitivity: +1 dBu for full output.
Input Impedance: 20 kohm.
Input Connectors: 1/4-inch TRS balanced phone jack and Female XLR.
Distortion: <0.006% THD, 1 kHz, 1 dB below clip, 22 kHz measurement bandwidth.
Frequency Response: 20 Hz to 20 kHz, +0/–0.2 dB; <2 Hz to >120 kHz +0/–3 dB.
Controls: Power switch, bridge mode switches, detented level controls (these may be made tamper-proof).
Indicators: AC Present, Operate, Signal, Bridge, Clip, Temp, Fault.
Protection Microprocessor supervised: Over- temperature, DC on outputs, output stage over- load, inrush current surge, power fail and brownout.
Noise: <–100 dB ref. full output 20 Hz to 20 kHz measurement bandwidth.
Slew Rate: >50 V/microsecond. Damping Factor: >200 ref. 8 ohm.
Output Connectors: Binding post or Speakon® options.
AC Power: 230 volts AC nominal, 2200VA, all channels driven.
Dimensions: 89mm (3.5 in.) x 460 mm (18.2 in.) x 483 mm (19 in.).
Weight: 11 kg (24 lbs.).

Output power
2-ohm Dual (per channel): 330W**
4-ohm Dual (per channel): 300W
8-ohm Dual (per channel): 170W
4-ohm Bridge-Mono: 660W**
8-ohm Bridge-Mono: 600W
*1 kHz Power: refers to maximum average power in watts at 1 kHz with 0.1% THD+N.
**Note: 2 ohm and 4 ohm bridge are at 1% THD.